If you set excluded architectures for the simulator to arm64 it will compile.
#Ios pod file archive
So I guess we should be good if we archive our app choosing that as a run destination. However, I noticed the documentation says (highlighted in the attached picture) that this setting will be ignored when we choose "Generic iOS Device/Any Device" as the run destination, since it doesn't define any specific architecture. During archiving apps usually take the "Release" configuration and since this will be creating a release build considering only the active architecture of the current run destination, with this approach, we may lose the slices for armv7, armv7s, etc from target build. One thing I was concerned about that what will be the impact of this when we actually archive the libs/apps. Follow the steps in the deploy steps official documentation. Target.build_configurations.each do |config|Ĭonfig.build_settings = "YES" Once you run flutter build ios a Podfile and Podfile.lock will be created for you in the ios directory.
#Ios pod file update
podspec, you can always update the settings during installation of the pods: post_install do |installer| However, if you don't have access to the. However, this could be necessary for successful linting of podspecs. So it should be the responsibility of the consumer project to override the setting by some means. I personally don't like the second line since pods shouldn't pollute the target project and it could be overridden in the target settings, itself. You have to do the same for the Pod project until all the cocoa pod vendors are done adding following in their Podspec. If you dont receive this prompt, you could change your POD file associations via your Control Panel.
#Ios pod file Pc
Your PC may ask you to choose a default program with which you want to open POD file extensions in future. If you are using custom XCConfig files, you can simply add this line for excluding simulator architecture.ĮXCLUDED_ARCHS = arm64 Change POD File Associations Computers are smart, but can sometimes be easily confused.To do that, navigate to Build Settings of your project and add Any iOS Simulator SDK with value arm64 inside Excluded Architecture. ipa file with the Xcode Archives organizer. xcarchive file that can be used to generate an. The artifact of an unsigned build is the. Basically you have to exclude arm64 for simulator architecture both from your project and the Pod project, ipa file is an iOS device application archive file that contains the iOS app.
0 kommentar(er)
